Dynamic Thin Material Roll Feed Options

Additional Feed Heads enable stock to be gripped on both edges. Available with hardened knurled, chromed, urethane-coated or chrome blast finished rollers.

Adjustable Mounting Plate has a hydraulic jack for quick, easy feed height adjustment of ±3". OBI presses may require the plate to be shimmed from the bolster to clear the leg of the press.

Top Guard shields the moving carriage on the feed. Easy to install and remove.

Rear Guard and Roller guards the thrust rod or motor while supporting incoming material with roller. An additional top roller and/or cascade rolls can be added to introduce material into the feed system.

Pilot Release System releases material where camber is a problem or where the pilot can't pull forward due to material softness. Used for very thin (.020" and less) and narrow material.

Dual Grippers are standard on feeds 15" or wider. They are offered as an option on smaller feeds running 5" wide material at .060" or greater.

Tandem Block provides extra pulling power for thick narrow material that is not wide enough to grip on both edges and requires an extra feed head. This reduces the total amount of feed length by 13/8".

Bridge Gripper is used for applications requiring greater clamping force or material with non-markable surface. Provides a full-width grip on material up to 12" wide.

For information about custom options for special applications, contact Minster Automation at sales@minster.com or 419-628-2331.