Optima Die Clamps
Features:
• A safe, quick and simple way to clamp Dies.
• Easily inserted into existing T-Slots. Easy positioning without additional fixing.
• Manually operated. No hydraulic or pneumatic components necessary.
• Clamping force is obtained through the patented OPTIMA Toggle System. Full pressure is achieved quickly and easily by turning the low torque “power nut” 180°.
• Self-locking in clamped position.
• Available for most Minster presses.
Hilma 5.2 Ton Sliding Block T-Slot Clamps
Features:
Single acting, sliding hydraulic block type clamps with spring return used to clamp dies to bolster and slide.
Each clamp generates 5.2 tons of clamping force, using a pre-set system pressure of 3500 PSI. Clamping height from face of bolster or slide is 2” ±0.030” standard, while the clamps have a maximum stroke of 0.47”.
A control station is located on the press upright, allowing easy access to clamp/unclamp selection and lifter activation. Quick Die Change control is interlocked with the press controls to prevent clamping while the lifters are in the raised position, and to stop the press in the event of loss of electricity or hydraulic pressure.
Multiple clamping zones for both the slide and bolster provide reliable operation in the event of a hydraulic pressure loss. Locking screw used to fix position of rear bolster clamp in T-slot during change-over of tools with similar dimensions. Quick disconnects supplied for union between clamp hose and manifold block. Includes complete installation of air/oil pump, valves, controls, manifolds, clamps, and all necessary equipment to operate the Quick Die Change system. Available on Minster E2, P2, and P2H series machines.
Benefits:
• Reduced Die Setting Time.
• Ease of Operation Increases Safety.
• Even Clamping Pressure Eliminates Over- or Under-Torqued Bolts.
• Minster Installation Prevents Machine Down-Time to Retrofit for Quick Die Change System.
• Excellent Warranty and Customer Service Make For an Outstanding Value.
Hilma 7 Ton Hollow Piston Cylinder Clamps
Features:
Single acting, sliding hydraulic piston type clamps with spring return used to clamp dies to bolster and slide.
Each clamp generates seven tons of clamping force, using a pre-set system pressure of 3500 PSI. Clamping height from face of bolster or slide is 1”-3” while the clamps have a maximum stroke of 0.47”. A control station is located on the press upright, allowing easy access to clamp/unclamp selection and lifter activation.
Quick Die Change control is interlocked with the press controls to prevent clamping while the lifters are in the raised position, and to stop the press in the event of loss of electricity or hydraulic pressure. Multiple clamping zones for both the slide and bolster provide reliable operation in the event of a hydraulic pressure loss.
Quick disconnects supplied for union between clamp hose and manifold block. Includes complete installation of air/oil pump, valves, controls, manifolds, clamps, and all necessary equipment to operate the Quick Die Change system. Available on Minster E2, P2 and P2H series machines.
Benefits:
• Reduced Die Setting Time.
• Ease of Operation Increases Safety.
• Even Clamping Pressure Eliminates Over- or Under-Torqued Bolts.
• Minster Installation Prevents Machine Down-Time to Retrofit for Quick Die Change System.
• Excellent Warranty and Customer Service Make For an Outstanding Value.
